PCBA Test Fixture Design Services: Hardware and Software

Software Developing Services using LabView and LabWindows/CVI

Are you about to launch manufacturing of your product but does not know how to test your electronics?

At Microelectronicos we offer you our automate test fixture solutions for PCBA’s that required to be tested as a sub-assembly units before going into the final product. Our team of engineers have years of experience designing test fixtures for pcbas mostly used in medical and aerospace industries.

How to start?

Bring us your test requirement document and board documentation (schematics, Gerber files, 3D Files, firmware if necessary) and we will provide you with a quote of our test fixture development services.

Figure 1. Overall hardware architecture for a PCBA test fixture, interface with DUT via pogo pins.

Overall architecture

Figure 2. Overall hardware and Software architecture for a PCBA test fixture, interface to automated test software.

Equipment

Figure 3. Overall hardware and Software architecture for a PCBA test fixture, interface to automated test software.

Our typical solution for PCBA test fixture is shown in the Figure 3. We used a mixed-approach of off-the-shelf bench instruments (like oscilloscopes, function generators, programable power supplies, etc) which in general tend to be low-cost in addition to the typical PXI chassis rack configured with DAQ boards and other dedicated instrumentation capabilities (relay switching, DMM, high-resolution ADC’s and DAC’s, etc) . This architecture allow us to get the most of two worlds in different electronics test scenarios (configuration flexibility, performance and low costs).

Our Solution

Figure 4. Overall hardware and Software architecture for our PCBA test fixture solution, interface to automated test software.

Pogo Pin Mezzanine board (to DUT)

Figure 5. As part of our test fixture solution we will design a costumed pogo pin interface board for your PCBA.s

One of the key elements of a successful test fixture is the interface with the PCBA DUT (Device Under Test). Our custom Pogo-pin Mezzanine board will interface with your PCBA and realize all the signal conditioning necessary to interface your device with all the instruments. We also have included key elements in the design like:

  • EEPROM Memory to store Test fixture calibration information, serial number, offset values, typical values, calibration date, regular test fixture users, calibration temperature, etc. All these elements are key to maintain traceability of your test equipment and comply with regulatory guidelines (i.e. IQ, OQ, PQ for test fixtures for Medical designs).
  • On board temperature sensor that will allow you to monitor high power, temperature sensitive components like: heat sinks, voltage regulators, shunt resistors, high power MOSFETS, etc.
  • Programmable ON/OFF switch, so your DUT can be powered under software control.
  • RGB Led to indicate test progress and status: Warning, failed, pass, test halted, test skipped, etc.
  • Interface to Logic Analyzer: will allow to analyze communication protocols like: I2C, SPI, USB, CAN and Serial, on-the-fly.
  • Clamp to control insertion force of your PCBA into the pogo board.